Chris Kilpin Machinery

logo2

MISTRAL_200

 

Mistral 200

  • End milling angle 45° Rh - 90° - 45° Lh and intermediate angles
  • Milling speed set by inverter from 4000 to 7000 rpm.

     (adjustment on control console)

  • Set up to take integral safety guard around bar being machined to provide maximum noise abatement
  • Completely automatic milling cycle (hood closing, tunnel closing, bar milling, milling unit return and stop, tunnel re-opening, hood re-opening and vice re-opening)
  • Maximum noise and fumes abatement
  • Chips recovery by means of dedicated drawer
  • Patented system that allows profile positioning without the need for goniometries
  • Rapid milling unit approach to bar (intercepted by photocell)
  • Microdrop lubrication with pure oil
  • Milling carriage slides along linear guide-ways and recirculating ball blocks
  • Work table height 922 mm
  • Max. milling tool size Ø200 mm
  • Double working pressure servocontrolled in low pressure
  • Set up for fumes extraction
  • Non-abrasive work table that will not damage painted profiles
  • Adjustable milling carriage stroke
  • Quick change milling tool unit
  • Milling tool unit balancing system
  • Milling units magazine
  • Oleopneumatic milling tool carriage feed
  • Carriage stroke: X max=445mm
  • Milling depth: Y max=76mm,
  • Milling unit maximum height:Z=125mm
  • Three phase motor: 1.5 Kw (2Hp)  –  2850 rpm. –  eurovoltage 400V– 50Hz
  • Working capacity: see attached diagram
  • Working pressure: 7 bar
  • Work cycle air consumption: 25 Nl

 

info

 

We use cookies on our website. Some of them are essential for the operation of the site, while others help us to improve this site and the user experience (tracking cookies). You can decide for yourself whether you want to allow cookies or not. Please note that if you reject them, you may not be able to use all the functionalities of the site.

Ok